61°F
weather icon Clear

Peeling paint occurs when wood contacts concrete

Q: I notice that the paint peels off much too often at the bottom of the side jambs on my front door. I repaint these areas, but a few months later, the paint near the concrete starts to peel. I hate painting, so can you tell me what is happening and how I can fix it?

A: Painting is no fun. The only thing worse than painting is having to paint again and again. Unfortunately, your peeling problem is fairly common.

If you look around your house, you will probably notice the same dilemma at other locations where wood meets concrete, such as the wood frame around the garage. This happens because concrete loves to drink up water and, as it does, it slowly releases moisture. So, any wood that is in contact with the concrete gets a little damp.

The dampness wicks up the wood and breaks the bond that holds the paint to the wood. So, what can you do about it?

You will need to scrape and sand down the area so that the bare wood is exposed up to 1½ feet above the concrete. You can do this with paint scrapers and 80-grit sandpaper. Scrape the majority of the peeling paint away, and then get rid of stragglers with the sandpaper. The 80-grit paper will leave a scratchy surface, which is ideal for a good surface bond.

Next, you want to create a gap between the wood door jamb and the concrete. You can use a thin piece of wood (¼-inch thick), lay it down on the concrete, and then place a hand saw on top of it. You can easily cut the jamb and molding with a few passes. After the gap is cut, either clean out the debris with a shop vacuum or blow it out with compressed air.

Protect the surrounding area by covering it with blue painter’s tape. Spread the tape on areas you don’t want to be painted, including the concrete under the gap you just cut. Use several layers so you don’t stain the concrete.

Now you want to spread a little water-repelling love on the bare wood. Use a “paintable” repellent (you can buy it at a home center or paint store) and brush it on the bare wood. Wipe off any repellent that doesn’t absorb into the wood. Don’t forget under the jamb that you just cut, as you need to get the repellent under there to seal the end of it.

You can slather some of the repellent on a thin piece of indoor/outdoor carpet and run the piece into the gap and rub it on the underside of the jamb. You can use anything thin that will both hold the paint and slide under the jamb, such as a putty knife.

The next step is to apply a primer over the repellent. The label on the repellent’s bottle will tell you how long to wait before brushing on the primer. Brush it on in the same manner that you applied the water repellent.

Finally, apply two coats of latex paint to the jamb, and also to the underside of the jamb. This is a pretty straightforward process that should get you back into painting only every couple of years instead of every couple of months.

Mike Klimek is a licensed contractor and owner of Las Vegas Handyman. Questions may be sent by email to handymanoflasvegas@msn.com. Or, mail to 4710 W. Dewey Drive, No. 100, Las Vegas, NV 89118. His web address is www.handymanoflasvegas.com.

THE LATEST
Create a spa-like bathroom

One of the biggest trends in master bathroom remodels is to eliminate the tub and then enlarge the entire shower area.

Mid-October is best planting time of year

This is the best planting time of the year right now. When planting trees, shade the south and west walls and windows of a home to reduce the cost of summer cooling.

Soil consistency in landscape makes irrigation easier

Whether you add compost to the existing soil at planting or bring in a totally different soil mix, make sure the soil is as consistent as possible throughout the landscape. Making the soil the same when planting makes knowing when to irrigate much easier to figure out and schedule.

Repairing wood subfloor typically requires cutting flooring

When replacing the wood subfloor around the toilet, you may have access to the joists so you can nail the new subfloor patch to them. Typically though, you will have to cut back the flooring to expose the joist’s surface, and you can do this with a circular saw.

Location is all-important when selecting landscape plants

Now is the optimum planting time during the fall and also the time when nurseries begin their fall planting sales. Location is all-important when selecting landscape plants and matching them to their correct landscape microclimate.

Window tint: Easy and economical way to boost energy efficiency

Window tinting can protect carpet, wood flooring and window treatments. In fact, today’s generation of window films also can keep out heat and filter light, which also increases fading in a variety of household materials.

Water plants if it’s a hot, bright, windy day

Most of the damage done to plants during high summer temperatures was due to a lack of water. And if there are strong winds, they also use more water. The bottom line, if it’s a hot, bright, windy day, it’s time to water now.

Glass shower doors must be removed to fix rollers

Most doors on tub enclosures hang from the top rail and slide along its guide track. If the door doesn’t roll smoothly, you must remove the doors and inspect the wheels to see what needs fixing.

Planting calendar will help when growing vegetables

It is important to select good varieties of vegetables to plant in the fall, and the publications by Dr. Sylvan Wittwer, formerly of Logandale, make some solid, old-fashioned varietal recommendations he has had success growing in this area.